Kraft Masking Paper,Re-Moistening Masking Paper,PMMA Sheet
Wuxi Yagela Nonferrous
Metals Tube Factory
Service
Add Favorite    |    Set as Homepage    |   Service
International Call: (+86 510) 8329 6092

Aluminum alloy cylinder,Precision shaft (piston rod),Anodizing

 
Product Catalog
The products are exported to many countries ...
> Piston Rod
> Tie ROD
> Stainless Steel Tube
> Aluminium Alloy Tube
> Anodizing
 
Service Center
Use the following methods to contact us
Add:NO.329 Xilu Load ,Outang Shengfeng Village,Qianqiao Town,Wuxi,Jiangsu
Manager:Mr.Wen
Mobile phone:+86-13771560216
Tel:+86-510-83296092
Fax:+86-510-83291101
Postcode:214153
Contact:Carol
Email:sales@yagela.com
Skype:wuxiyagela
MSN:yagela@hotmail.com
>>Readmore
 
News
The cause of the piston rod to be bending
Publisher:admin  AddDate:2013-4-29 2:08:55  Hits:473

The loader boom cylinder piston rod as the ratio of length and diameter is greater than 10, the bending occurs frequently in using. On the surface, is the insufficient of the piston rod bending strength, but actually it has a direct relationship with the loader frame and rocker arm structure.

Causes of the piston rod bending

1 boom cylinder with both ends of the rack and the movable arm is connected with a tilt phenomenon, the support width is too small. (the assembly and adjustment of gap assembly to adjust the clearance between the improper or flank wear serious, should increase the support width.)

2 boom cylinder bottom discharge sedimentary accumulation and boom cylinder outer side of the bottom wear. (sedimentary material accumulation is seriously, rotating friction is larger.)

Prev:characteristics of cylinder block casting
Next:The quality identification about NSK bearing
    
 
Home   |   About us   |   News   |   Products   |  Message   |   Service
Copyright 2012 © Wuxi Yagela Nonferrous Metals Tube Factory,Aluminum Alloy Cylinder,Precision shaft,piston rod
Add:NO.329 Xilu Load ,Ou Tang Shengfeng Village,Qianqiao Town,Wuxi,Jiangsu  | 
 |  Power by juntong